Logix Designer Export Wizard: Register Setup

Previous Wizard Page Next Wizard Page

To access this wizard:
1. In the Project pane, expand Modules, and double-click the CPU.
2. On the EtherNet/IP page, in the Logix Designer Export section, click Export to Logix Designer.

Use this wizard to export EtherNet/IP communication data tags and example synchronization ladder logic. The exported components can then be imported to a Rockwell Logix Designer project. For more details, see Using Logix Designer Export Components.

For each connection, enter the following:
- The number of PLC Input Data registers
  
  This is the same as the number of output RMC registers.
- The number of PLC Output Data registers
  
  This is the same as the number of incoming RMC registers
Do NOT include the Sync register in these register counts!
Double-check the Starting Address locations in the RMC to make sure they are correct. If they are not correct, cancel the wizard and change the locations on the EtherNet/IP page of the CPU Properties dialog.